Building system and need advice
For the head unit I have a Nakamichi TD-560-my father says it was good at the time and it still works.
For amps I have two available.
Rockford fosgate p4004 or alpine mrv-f353
The rockford looks nicer....
for music i would probably get an mp3 player to plug into the input of head unit.
I have a few different 6 by 9s:
audition model 69TR53 ( 8OHM impedance, max power 150w, 60oz magnet circuit) the magnet on these is pretty big
Also have sparkomatic sk693, 10oz, 40W norm-80W max 4-8 ohms 30-17,000Hz. the magent on these looks pretty small.
Also have visonik v629a- they are 6 "x 9" 2-Way Full Range Speaker,
200 W Rms 200W Rms, 400W Max 400W Max, Frequency Response 50 Hz - 22 kHz, Sensitivity 90.2dB 1W/1M
These look cool, but im told need a lot of power. http://translate.google.ca/translate...%26channel%3Ds
the link above is one of the few things i could find on them.
I was thinking of putting the 6 by 9s in the rear hatch area possibly in the side plastic. Thinking of maybe a 8 or 10 inch sub in a stealth box on the drivers side which i would make.
also have some speakers 4inch speakers. crm-40.
I listen to dance, trance, house, rock, and some drum and base.
I do not need to be heard by the neighbours just want something that sounds better then the crap gm put in there.
All comments and advice are welcome.
In fact, if you don't have a Monsoon system then you don't have speaker grilles in the rear quarter trim panels. Only the Monsoon system had hatch area speakers. Check your door sticker for option code UZ7 to confirm if you have Monsoon or not.
The Rockford is a 4-channel amp and the Alpine is 5-channel. You could use the Alpine to power door and sail panel speakers (6.5" round) plus a sub. With the Rockford, you would be looking at getting another amp for your sub.
Also just checked the door speakers and their a kenwood with looks like a tiny speakers in the middle. I will take them out later for the model number. Hoping to possibly keep them there pick up some sail panel speakers and the sub for the stealth enclosure.
I already have a fair bit of speaker wire that are different gauges. If i can find the speakers suggested used I have no problem with that.
Edit:
Found a alpine type R 12inch(500w rms, single voice coil) for 50 used so would that be good to use in the stealth enclosure and work ok with the amp I have?
Last edited by joe77; Mar 22, 2010 at 09:23 AM.
heres technical article http://manuals.harman.com/INF/CAR/Bo...re%20Sheet.pdf
any input would be appreciated as i still dont understand these specs all that well
Last edited by WhiteBird00; Apr 9, 2010 at 12:40 PM.






