Pyton 1401 install help
Thread Starter
Teching In
Joined: Nov 2007
Posts: 30
Likes: 0
From: Arizona
Pyton 1401 install help So I have a Python 1401 alarm and an Xpresskit bypass module PLJX. While I am no stranger to soldering wires or disassembling the vehicle, I've never installed a kit like this before.
Directions are of course nonexistent online and I have no interest in paying an installer 200$ to do this.
So my questions (thank you in advance for any help)
How does the bypass module relate to the actual Python controller?
Is this a case of Python harness -> module -> existing wiring?
Or should they both by tapped into the existing vehicle wiring?
Best spots to mount all these boxes (with an eye toward troubleshooting)?
I'm sure I have more questions as I look at it, so if anyone has a good basic install guide for this type of device I'd be very grateful.
Thanks,
-JB
Directions are of course nonexistent online and I have no interest in paying an installer 200$ to do this.
So my questions (thank you in advance for any help)
How does the bypass module relate to the actual Python controller?
Is this a case of Python harness -> module -> existing wiring?
Or should they both by tapped into the existing vehicle wiring?
Best spots to mount all these boxes (with an eye toward troubleshooting)?
I'm sure I have more questions as I look at it, so if anyone has a good basic install guide for this type of device I'd be very grateful.
Thanks,
-JB
Thread Starter
Teching In
Joined: Nov 2007
Posts: 30
Likes: 0
From: Arizona
Cool. I was looking at the manual, I'm presuming I have the VATS passlock 2 version (2002 firebird). I've pretty much concluded that I should tackle this one step at a time.
First the Bypass module, then the remote system itself. Any other tips for one of these installs or mistakes to avoid?
First the Bypass module, then the remote system itself. Any other tips for one of these installs or mistakes to avoid?
