Box & Polyfill
It's a JL 10W6v2 in a subthump driver side stealth box, and a Kicker KX600.1 amp.
Last edited by DreamState23x; Oct 9, 2005 at 12:50 PM.
I haven't used that rule of thumb in a while. I might be off a bit, but atleast a 1/2lbs and you'll be fine.
Ok. Rule of thumb on polyfill is: about 1 lbs per 1ft^3.
Last edited by Richiec77; Oct 9, 2005 at 04:31 PM.
Being that your sealed box is only ,025 less than required, I don't think that it will make that big of a difference.
BUT...1/2 pound would make a difference and make it play a little lower.
It also helps decrese Standing waves. That alone can increase appairent space. It is worth it to use it. Just because your speaker is in the Min. Required doesn't mean it's operating at it's optimum. Go for the fill and don't look back. It'll help out alittle.
Basically If i put 8ounces in there it is going to fill up the box, then the sub is going to sit down in the polyfill.. Good or bad.
Trending Topics
The Best V8 Stories One Small Block at Time
Basically If i put 8ounces in there it is going to fill up the box, then the sub is going to sit down in the polyfill.. Good or bad.


