how to wire two 10's to factory deck??
TECH Apprentice
Joined: Jul 2006
Posts: 348
Likes: 0
From: Gainesville, FL
In order to wire two tens to your deck youll need an adaptor called a line output convertor. There about $20 at Best Buy and Circuit City. This just splices into your factory wiring and will give you the RCA outputs for your amplifier. Im running this setup in mine and it works great... love the sleeper system look
Thread Starter
TECH Fanatic
Joined: Jul 2006
Posts: 1,179
Likes: 0
From: North Bay, Ontario
Originally Posted by firebird5134
In order to wire two tens to your deck youll need an adaptor called a line output convertor. There about $20 at Best Buy and Circuit City. This just splices into your factory wiring and will give you the RCA outputs for your amplifier. Im running this setup in mine and it works great... love the sleeper system look
Thread Starter
TECH Fanatic
Joined: Jul 2006
Posts: 1,179
Likes: 0
From: North Bay, Ontario
Originally Posted by firebird5134
youll need the line output convertor as well as a wiring kit for the amp. Other than that your all set. Expect to spend around $60 total if you install it yourself
TECH Resident
iTrader: (3)
Joined: Dec 2002
Posts: 863
Likes: 0
From: Showing Italians the power of LS1
The easiest way of doing this is to purchase two wiring harnesses for your radio; one that plugs into the factory radio, and one that plugs into the factory wiring harness that plugs into the radio. Wire both of the wire ends of both of those harnesses together, and connect the line output adapter between them on the speaker leads. this way you are not cutting any factory wire, and can revert to the factory setup in seconds. Here's a thread discussing it with part #'s: https://ls1tech.com/forums/showthrea...tput+converter
see post #28.
see post #28.
