HUD in a Camaro
Thread Starter
TECH Addict
iTrader: (63)
Joined: Dec 2004
Posts: 2,343
Likes: 2
From: Sandy Ego, Ca.
HUD in a Camaro Well it seems its a bit closer....take notice that in the article the guy who did the install, in a vette, didn't have the special glass. The tricky part seems to be how to modify the dash to accept the unit and the controls....
So..its not impossible
http://joshker99.home.comcast.net/hudinstall2.htm
So..its not impossible
The factory HUD cars have a special HUD windshield that is not necessary as the projections shown above are taken on my non-HUD glass in direct sunlight.
http://joshker99.home.comcast.net/hudinstall2.htm
Thread Starter
TECH Addict
iTrader: (63)
Joined: Dec 2004
Posts: 2,343
Likes: 2
From: Sandy Ego, Ca.
MOre Info
http://members.***.net/corvette/hud.htm
COST ISSUES
From GM Parts Direct you can buy a projector for about $300 including shipping.
A dimmer switch is $75 including shipping
A bezel is about $16 plus shipping.
The 11 pin harness is only custom made & not for sale from GM. Try
searching corvetteforum.com for people who make them if needed.
It is also recommend that you buy or borrow a dremel with a right angle.
That will cost around $100.
http://members.***.net/corvette/hud.htm
COST ISSUES
From GM Parts Direct you can buy a projector for about $300 including shipping.
A dimmer switch is $75 including shipping
A bezel is about $16 plus shipping.
The 11 pin harness is only custom made & not for sale from GM. Try
searching corvetteforum.com for people who make them if needed.
It is also recommend that you buy or borrow a dremel with a right angle.
That will cost around $100.
I know it's a whole different car and setup but here is a clever and pretty low cost build I found.
http://www.honda-tech.com/zerothread?id=1436211
Don't cry because it's a Honda site, this is a clever idea that could work for camaros as well
http://www.honda-tech.com/zerothread?id=1436211
Don't cry because it's a Honda site, this is a clever idea that could work for camaros as well
Trending Topics
any luck installing this in an f-body? i was thinking of getting a late bonneville HUD control for the trans am dash and putting it where the TCS switch usually is (custom fab) and using it with the z06 hud. possible?
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
