Sound Deadener
TECH Fanatic
Joined: Oct 2006
Posts: 1,003
Likes: 3
From: Champaign/Chicagoland
Where at in the car are you planning to use it? I would get some thicker sheets as well and at a minimal use them for the speaker locations and entire door if possible -- use the liquid anywhere else for the most part.
I used deadener for the doors and spray on for the inside fenders and hatch area. the stuff is very lightweight compared to the sheets and way much easier to use plus not too expensive and you can buy as much or little as you need, only$6 a can. 1 can will just about cover each wheel well from the inside and 1 can for the ttop/tank area. I used the sheets behind all speakers and the entire door in/out of the door skin. HUGE improvement!!!!
Thread Starter
TECH Senior Member
iTrader: (4)
Joined: Dec 2003
Posts: 5,276
Likes: 1
From: Arlington TX
I'm planning to use it in a couple of areas that I can't get a sheet of deadener into. I just want to quiet a rattle I have and I figure this would do it. It won't take much to do the job
Teching In
Joined: May 2007
Posts: 41
Likes: 0
The first step I took in sound deadening my car was the Elemental Design V3. It is super easy to put on. I would've said the only down side is the wait time to dry, but after doing the entire car in with eD V1, wait time isn't that bad compared to the apply time of a peel and stick in tight areas. V1 made a bigger difference overall though.
I did the entire floor of my car in eDead v1 as well as the doors, sides and hatch area. It was a TON of work but the car is much quieter inside now. All the creaks and groans are gone.
Hey, if you are interested in doing V3 or any elemental designs mat products call up NON SPONSOR I will get you a decent discount.
Last edited by 2MuchRiceMakesMeSick; Jul 23, 2007 at 07:15 PM.
Trending Topics
Thread Starter
TECH Senior Member
iTrader: (4)
Joined: Dec 2003
Posts: 5,276
Likes: 1
From: Arlington TX
the V3 is actually what I was looking at using. It will be the 1st layer and then I'll use a peel and stick product for other areas. There's no way I would expect to get great results with just V3
Funkster send me a pm
Funkster send me a pm
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
