zzracer

iTrader: (33)

I have a 99 z28 ,little over 3500lbs on this pass.
LS2 sbe, hand ported 799s, 236/242 cam, full Bolton's
Yank Pt4000 converter,built 4l60, Viking coilovers up front,8.8 rear with 3.08 gears. Joncr96z tune.
Drove 2 hrs round trip with the drag radials on. That's the best part for me!
Track conditions sucked. No prep, bad head wind blowing the tree around it was so bad. Loosened the coilovers up and managed to pull off a couple 10 sec. Passes.
Going to install 3.73 gears now before I go back.
Please add me to the 10sec club.
Thanks!

SLV_WS6

iTrader: (48)

Is it stroked? Is it NA? What intake etc? Nice pass

zzracer

iTrader: (33)

Stock bottom end LS2,stock stroke
Fast 102 intake,102 tb,
Hand Ported 799s shaved .030
236/242 cam,ewp,underdrive pulley
Naturally aspirated
Thanks!

SoFla01SSLookinstok

Great job man! That thing gets it done. The real deal driving to & from the track. Awesome!

zzracer

iTrader: (33)

Thanks! Hope to have my 3.73 gears in this week if I can get it to 60 like I think it should it aint done. We will see.lol

z28241

iTrader: (13)

Congrats! Tell me more about your set up, milled .030, did u run into PTV issue? Fly cut pistons? Which head gaskets? I ask because I have similar cam profile and I have to ask..

Aaron at SDPC

Congrats!

zzracer

iTrader: (33)

I am running .051 gaskets and I had to fly cut the pistons around .120 so those stock pistons are getting thin.
Pushing the limits but it's working.
Thanks guys!

z28241

iTrader: (13)

nice,since heads were milled .030,i figured there was some more work involved, where are you at compression wise? also cc?

zzracer

iTrader: (33)

11.3, 62 cc chambers

z28241

iTrader: (13)

Nice!

SLV_WS6

iTrader: (48)

Very nice man

Firebirdmuscle

iTrader: (16)

Nice times. Good running car.

zzracer

iTrader: (33)

Thanks guy's!

Mike Morris

iTrader: (55)

Good job!!!