Can't get fluid to flow out of bottom of master cylinder
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: May 2006
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
Can't get fluid to flow out of bottom of master cylinder
So i got my 383 fired up last night, sounds great, idles well.
However my clutch pedal is just flopping around, I disconnected the slave and pumped the clutch and tried to get the fluid to go down through the master, no luck, so I disconnected the line going into the master cylinder and I still can't get fluid to go through the master cylinder and out of the bottom hole that the slave cylinder connects to.
not sure what to do.
However my clutch pedal is just flopping around, I disconnected the slave and pumped the clutch and tried to get the fluid to go down through the master, no luck, so I disconnected the line going into the master cylinder and I still can't get fluid to go through the master cylinder and out of the bottom hole that the slave cylinder connects to.
not sure what to do.
#2
TECH Addict
Join Date: Jun 2009
Location: Tulsa, OK
Posts: 2,012
Likes: 0
Received 0 Likes
on
0 Posts
Have someone push the clutch to the floor, and hold it there. Put your finger tightly over the hole where the line goes, then have them let off the pedal. Repeat as necessary.
#3
TECH Apprentice
iTrader: (2)
Join Date: Jul 2004
Location: Cypress, Ca
Posts: 343
Likes: 0
Received 0 Likes
on
0 Posts
sounds weird, have you tried bleeding the system. and don't press on the clutch when doing so. if you don't know how to bleed it hit me up i can help out. i just swapped out my master cylinder and bled the system.
#4
On The Tree
Thread Starter
iTrader: (2)
Join Date: May 2006
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
seems like it is backed up, any way to clean it out or some chemical to use to open it up? or should I just keep using the compressor to blow in it?
how fast should the brake fluid be coming out the bottom end of the master cylinder, just a little at a time or pretty much free flowing?
Trending Topics
#8
On The Tree
Thread Starter
iTrader: (2)
Join Date: May 2006
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
I pulled the master, is there supposed to be any force against the plunger when you push on it? Barely any fluid goes through the master even with just the reservoir connected, heading to kragen to pick up a replacement. Let me know if I should try something else, thanks.