700r want shift out of first
#4
On The Tree
Join Date: Aug 2010
Location: Warren Michigan
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
If your positive it wont shift out of low gear, remove the round domed steel cover near the rear of the transmission with a screw driver & hammer. Careful not to poke a hole in it.
Slide the governor out, and inspect the plastic gear on the end.
They make a replacement gear, but it may be simpler for you to replace the entire governor. If your replacing the entire governor, try to match the weights & springs.
Slide the governor out, and inspect the plastic gear on the end.
They make a replacement gear, but it may be simpler for you to replace the entire governor. If your replacing the entire governor, try to match the weights & springs.
#7
On The Tree
Join Date: Aug 2010
Location: Warren Michigan
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#9
On The Tree
Join Date: Aug 2010
Location: Warren Michigan
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
If the tv is stuck, the vehicle will make a 1-2, just at a very high rpm (wot type rpm-48-5400) Test it in the air if needed to confirm.
To confirm if the tv is stuck-attach a pressure gauge just above the shifter location. There is a 1/8 pipe plug in this location.
If pressure is 150+ in d at idle, its stuck. It should be 75-80ish at 0 throttle.
To confirm if the tv is stuck-attach a pressure gauge just above the shifter location. There is a 1/8 pipe plug in this location.
If pressure is 150+ in d at idle, its stuck. It should be 75-80ish at 0 throttle.
#10
TECH Fanatic
#13
TECH Fanatic
iTrader: (3)
Join Date: Jan 2008
Location: Corpus Christi Texas
Posts: 1,519
Likes: 0
Received 0 Likes
on
0 Posts
When I trashed my second 700r it would go to 2nd but had no gear. I would hold it in 1st til 4000-4500rpm then bump it to 3rd. 2nd gear was the only thing gone.
Dont know if that will help but never know
Dont know if that will help but never know