1nastyss

iTrader: (12)

I have a raptor shift light, just trying to get a good idea of where to mount it. Thanx

SS 1LE

iTrader: (7)

Don't have any pictures, but mine is mounted on the steering column. I have seen some mounted on the A-pillar as well, or inside of the AC vent.

_JB_

iTrader: (33)

Blurry pic, but I have mine in the vent,



Have not been able to try it in the sunlight yet, the car is still in storage.

davered00ss

iTrader: (4)

I'll try to get a pic. Mine is mounted where the fog light switch use to be.

davered00ss

iTrader: (4)

Just took the pic.

White.Lightning

iTrader: (53)

Not a raptor, but you get the idea....





Andy

weaponZ

iTrader: (11)

mine is in the ac vent,but i dont have any pics at the moment

jj_z28

iTrader: (14)

I have no pics, can't really see it anyway. But here is a short vid of it doing its thing. It is a Raptor Shift Light.

http://media.putfile.com/RaptorShiftLight

WS6GoFast

mine is in my ac vent, you cant even tell its there until it light up, i dont have any pics of it though and the car is at my dads

PewterWSSicc

Here is a blurry pic of mine in the defrost vent on the far left.

davered00ss

iTrader: (4)

I have seen them cut into the trim piece around the gague cluster and like that a lot.

cjh

iTrader: (4)

For those who installed it in the defog vent, what are you using as your switched 12v source and ground? What are you using to secure it in place?

Thanks

99FormulaM6

iTrader: (21)

you can kinda see it...its in the little defroster vent

RaNsOm

iTrader: (2)

weaponZ

iTrader: (11)

double stick tape is holding mine and i found a thick pink wire that i tapped into for switched power(ignition)

99SilverZ

iTrader: (13)

PewterWSSicc

The raptor shift lights come with two parts that slide ovr the lights housing. I trimmed the back part of the vent out and slipped one piece on and then stuck it in. On the front I slipped the bigger piece over the lights body and that holds it very securely in place. As far as what I use for the 12V power source. I used whatever it was raptor said to use. If I remember right, mine is ran to the PCM and connects to a power source there.

LawmanSS

iTrader: (19)

My Harlan shift light is in the vent...I tapped the TCS switch for switched 12V, I ran a ground wire, and used velcro to hold the light in place...

Brian2001SS

iTrader: (1)

Same thing here. Even down to the velcro. Works great.

ls2 bait

iTrader: (11)