neodamonkey

iTrader: (7)

Looking to put both fron seats from a 2000 into a 99, problem is wiring harnes is different. Im guessing because of the year difference and becase tghe seats out of the 2000 has the lumbar support.

Question, are the wires going to the seat simply power and ground wires? If so i should be able to just tap the wiring harnes and power the seats to have lumber as well as seat adjustments.

Any help apprecitad

97ramsst

iTrader: (162)

I put power seats out of a 2000 in my 89 IROC and all I had to do was run a hot wire and a ground wire, but the seats didnt have lumbar. But I would think that a + and - would be all you need.

chupr0kabra

iTrader: (10)

I've got a shop manual for 2000 models here. What colors are the wires and what does the connector look like? I can tell you what goes where.


-Mike

neodamonkey

iTrader: (7)

I will take a look when I get home tonight and let you know

neodamonkey

iTrader: (7)

Can you PM me your number so i can call/text you when i get there? Im looking to splice the wires and get the seats in today around 6pm


Or does anyone else have a wiring diagram for a 99 ( where the seats are going into) so i know which wire on the harness is hot and which is the ground?

Thanks guys

chupr0kabra

iTrader: (10)

PM sent.


-Mike

pozesd99'

iTrader: (3)

i did the same but just swapped the rails. it was alot easier

neodamonkey

iTrader: (7)

Well i like the options of the 2000 that the 99 does not have, so if its just hot and ground id rather tap into that.

neodamonkey

iTrader: (7)

So does anyone else have the wiring diagram for both a 99 and a 2000?

Thanks