What TC for H/C and TNT 100-150 shot?
#1
TECH Enthusiast
Thread Starter
Join Date: Dec 2002
Location: Chattanooga,TN
Posts: 736
Likes: 0
Received 0 Likes
on
0 Posts
What TC for H/C and TNT 100-150 shot?
I thinking of going H/C along with my TNT kit what TC would work well with NA and No2? I have the Vig 3600 now but haven't sprayed it yet. I also wonder if the tranny hold any for H/C and TNT.
#3
TECH Enthusiast
Thread Starter
Join Date: Dec 2002
Location: Chattanooga,TN
Posts: 736
Likes: 0
Received 0 Likes
on
0 Posts
I know the Vig 3600 is a much higher stall thats why I'm asking about another TC for the setup listed above. I haven't sprayed on with my Vig yet and I was thinking of replacing it.
#4
Moderator
iTrader: (4)
Join Date: Nov 2001
Location: Montgomery, AL
Posts: 2,074
Likes: 0
Received 0 Likes
on
0 Posts
I would go with a TCI Super Street Fighter 3500. It is a proven converter and TCI will stand behind their product.
There is a guy at our local track that runs that converter behind a cam only LS1 spraying a 150 shot.
Low 11s to high 10s with 1.5 60s are the norm.
John
There is a guy at our local track that runs that converter behind a cam only LS1 spraying a 150 shot.
Low 11s to high 10s with 1.5 60s are the norm.
John
Last edited by JNorris; 03-13-2004 at 11:02 PM.
#5
TECH Veteran
iTrader: (1)
Join Date: Nov 2001
Location: Houston,TX
Posts: 4,167
Likes: 0
Received 0 Likes
on
0 Posts
I would look in the direction of a Yank 3600e, i know a few people with H/C setups and spray and they love theirs. not only that, but the one i have drivin, drives quite a bit better than the vigi3600 we use to have in our car. That is going to be the converter i will buy if i can get my 88 camaro setup. Good Luck
#6
TECH Enthusiast
Thread Starter
Join Date: Dec 2002
Location: Chattanooga,TN
Posts: 736
Likes: 0
Received 0 Likes
on
0 Posts
Well I was kinda thinking of sending the stall back to PI and getting a muti disc 3600 I'm sure its a lot tighter than the 3600 I have now. The only reason for that is becuase it would ony cost me $375 instead on $800-$900 for a different TC. Does anyone have one these TCs?
#7
Moderator
iTrader: (4)
Join Date: Nov 2001
Location: Montgomery, AL
Posts: 2,074
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 1ORANGEWS6
Well I was kinda thinking of sending the stall back to PI and getting a muti disc 3600 I'm sure its a lot tighter than the 3600 I have now. The only reason for that is becuase it would ony cost me $375 instead on $800-$900 for a different TC. Does anyone have one these TCs?