sidewayz28

iTrader: (24)

i was told by Trevor @ TSP that my true duals wont work with an after market cross member for a th400
what kinda set up you guys running? Will an ORY clear the th400 and cross member? Its going to suck going back to a cat back set up
anyone running an ORY to hooker cat back???

Gilbert@Ace Racing

Not sure if you guys are on the same page. But I have done several conversions on cars that had true duals. It might be that you have to have them modified for the new crossmember, but it's no big deal to have that done.

g

sidewayz28

iTrader: (24)

Thanks ratchthed,

this is the e-mail i got from Trevor@ TSP:
"Our true duals will not work with an aftermarket cross member. It will have pretty big clearance issues."

im wondering if i could just get a custom x-pipe..?

ss2000

iTrader: (45)

i have tsp duals with a bmr m6 crossmember and i don't have any issues. i plan on using the same crossmember for a th350.

sidewayz28

iTrader: (24)

sweet^
im going to use the one im getting in the swap; which is a Yank th400 cross member w/ a T/A mount.. definintly going to use it so i can get the T/A off the tranny

Z28/2002

iTrader: (27)

I'm running bullets off the headers

jermzz

iTrader: (18)

that must stink the **** out of your car.

Z28/2002

iTrader: (27)

Well there is about 12" of tubing after the header then the bullets. They turn out under the front seats

XpEdItIoUs

iTrader: (44)

Im running a dumped bullet on the end of the downpipe.