fuel rail covers on a carb intake?
#4
On The Tree
iTrader: (5)
Join Date: May 2008
Location: Moorhead Minnesota
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Here is one from a car show I went too. I believe this is the best picture I have. IMO, pretty ugly. (Though I dont really like them to begin with) To each his own.
(Sorry its the best pic I have, hope it helps)
(Sorry its the best pic I have, hope it helps)
#5
11 Second Club
iTrader: (11)
Join Date: Aug 2004
Location: TULSA
Posts: 453
Likes: 0
Received 0 Likes
on
0 Posts
The best cover I have seen was a set of sbc valve covers with holes cut in the sides for the plug wires to go through and they mounted right over the top the stock valve covers and coils.
https://ls1tech.com/forums/conversio...vers-ever.html
https://ls1tech.com/forums/conversio...vers-ever.html
#6
Staging Lane
Join Date: Apr 2008
Location: Shawnee, KS
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
The best cover I have seen was a set of sbc valve covers with holes cut in the sides for the plug wires to go through and they mounted right over the top the stock valve covers and coils.
https://ls1tech.com/forums/conversio...vers-ever.html
https://ls1tech.com/forums/conversio...vers-ever.html
Scott
#7
TECH Senior Member
iTrader: (127)
The best cover I have seen was a set of sbc valve covers with holes cut in the sides for the plug wires to go through and they mounted right over the top the stock valve covers and coils.
https://ls1tech.com/forums/conversio...vers-ever.html
https://ls1tech.com/forums/conversio...vers-ever.html
i did the same thing but filled in the left behind holes with epoxy, i also filled in the cheannels that run across the center for a tru smooth look.
Trending Topics
#9
Staging Lane
Join Date: Apr 2008
Location: Shawnee, KS
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Scott
#10
TECH Senior Member
iTrader: (127)
i was going to paint a glossy black or even carbon fiber print,
so i epoxied everything. also ground down the stock rubber and modified bolt and used a allen bolt and washer instead.
going to do a write up on the mods. the covers are painted black now,
they look like aftermarket smooth covers now
so i epoxied everything. also ground down the stock rubber and modified bolt and used a allen bolt and washer instead.
going to do a write up on the mods. the covers are painted black now,
they look like aftermarket smooth covers now