HP tuners question, VATS and Rear O2 sensors
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: Oct 2007
Posts: 223
Likes: 0
Received 0 Likes
on
0 Posts
HP tuners question, VATS and Rear O2 sensors
I am using HP tuners tonight to remove the VATS and disable the O2 sensors from showing no feedback.
Let me know if there is anything else I need to modify or edit. Just to get it to run.
Thank you
Let me know if there is anything else I need to modify or edit. Just to get it to run.
Thank you
#6
On The Tree
iTrader: (3)
Join Date: Aug 2011
Location: WA
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
I think this should be Bank 1 Sensor 2 and Bank 2 Sensor 2, right? "Sensor 2" is the post catalytic convertor 02's, and "Sensor 1" is the before the cat sensors? If not I cut the wrong plugs off my harness.
#8
LS1Tech Sponsor
iTrader: (5)
COT is 'cat overtemp' it is located in Engine Section of HPTuners. May want to lower your fan temperatures and remove skipshift (if this is a manual setup).
Jon
PSI
Jon
PSI
__________________
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
#9
how do you disable the codes to not report. Do i go to eng diag - dtc's and there are two columns SES enable and Error. The SES you check mark and the Error Mode has a drop down with no error reported, mil of first error, mil on second error and no mil light. this is the tune from my 07 chevy suburban with a twin turbo. I removed wye pipe and put staright pipe with sensor1 o2's