z28mccrory

iTrader: (7)

Hey guys... trying to get all the little loose ends figured out before i get this kit in my hands. The guy who currently had it said the following numbers on on the actuators and im trying to figure out what PSI they are. My goal is to run 8psi with a manual boost controller and im hoping these are the 5psi ones... if not i need to find a way to get other ones or a way to make these work.

430099-32
03319
24808

z28mccrory

iTrader: (7)

Tried doing a lot of searches today and no luck... google too..

If no one knows what mine is, any chance i can just get the part number and link to buy a pair of 5psi ones?

cablebandit

iTrader: (37)

i have the instructions on my backup drive downstairs....ill look in the morning and see if they have a number listed

z28mccrory

iTrader: (7)

anarchy99 (guy i bought kit off of) got back with me and said he thinks they are the lower pressure ones

These are the instructions i found http://www.classicgm.com/images/incon/

Am i missing something? I cant fine out where it explains how to actually adjust the wastegate actuators. anarchy99 told me i could adjust them to up the boost (im wanting to run 7-8psi) and i cant find any direction on how to do that.

onfire

iTrader: (17)

Use a mityvac and test them. Easy to see the crack pressure.

y2khawk

iTrader: (5)

the rods are threaded. Shorten them up to add preload and raise the boost pressure.

"stock" was half a hole preload and that gave about 5 psi on a stock cube motor.

cablebandit

iTrader: (37)

lol.....funny after all this time to see Harlan giving incon advice/info

z28mccrory

iTrader: (7)

Harlan has been helping me out in PM's also... big props to him

y2khawk

iTrader: (5)

still full of useless info i guess