C Murda

iTrader: (24)

ive read to tap in by the oil filter but does anyone have any pics of how theirs is set up? wheres the best place to get oil pressure for twin turbos? pics will be greatly appreciated.

sevanseriesta

iTrader: (34)

here you go hope this helps... This a block that was drilled and tapped above the oil filter.
I have twins that is why there are two fittings...

lifeisgood

iTrader: (4)

mine is taped into the oil filter adapter. theres a fitting on there for that.
we had to put a restrictor in line b/c the car was blowing the oil pressure gauge past 80.lol

C Murda

iTrader: (24)

so how exactly is this attached to the block? or what about this oil filter adapter?

sevanseriesta

iTrader: (34)

Mine replaces the stock one if that is what you are asking... If you are doing a single turbo just drill and tap the stock one.

Hugger Z

iTrader: (4)

For the APS kit, we just drilled and tapped that flat near the oil filter. Screwed in a T-fitting and connected the two lines.

SSilverSSurfer

iTrader: (8)

drill and tap the stock one or buy the one from tti

TXZ0603

iTrader: (1)

I drilled out the galley plug near the front of the block. Tapped it for 1/8 NPT, then put in my adapter.

F-BodyGuy98

well for wut its worth i have the STS kit for my 98 Z28 and i drilled the block above the oil filter....its drilled half way through from the factory and i just finished drilling it...good luck with getting her finished...be sure to give us some pics when ur done...