MUSTANGBRKR02

iTrader: (91)

So I have read where and how to tap the pan but not what size. I plan on running a -10 AN line. The fitting off the turbo is a 1/2 NPT to 10 AN is this the correct size for the pan also? Just seems like a big hole to drill/tap in the pan.

Thanks

Tally TransAm

iTrader: (17)

i used a weld in bung in my timing cover but that size sounds about right. if i recall a -10 AN is approx 5/8" hose

NightHawk

iTrader: (1)

I got a 1/2" to -10 for the turbo and for the pan as well.

MUSTANGBRKR02

iTrader: (91)

Yeah it just seems like a big hole to drill. I plan on doing mine in the next day or two. How is your install coming Nighthawk?

NightHawk

iTrader: (1)

Eh, it's going slooooowly lol. Between the SEMA show and a bunch of other BS I haven't had much time to work on it. Plan on dropping my K to do the pan and the solid mounts at the end of the week.

How's yours coming along?

MUSTANGBRKR02

iTrader: (91)

Mine is good. Have the mounts in. IC mounted up. Going to tap the pan next and get the kit together.

XtremeDime

iTrader: (16)

I was going to tap the front of the pan but there just wasnt enough room so I brought the fitting and pan to a welder and told him to make it work. Should get it back in a day or 2.

MUSTANGBRKR02

iTrader: (91)

I'm going to tap mine. Tomorrow if it doesn't rain.

NightHawk

iTrader: (1)

BTW, happy marine corps b-day man.

elias_799

iTrader: (8)

watch those solid mounts. it will be allot harder to pull the trans out with them.

MUSTANGBRKR02

iTrader: (91)

and put it in cant get the two top bolts. going to have to go from the top after i pull the intake.

Happy Bday to you too devil

elias_799

iTrader: (8)

i am switching to a bmr turbo k member and poly mounts for that reason, and to make some more room for the twins

MUSTANGBRKR02

iTrader: (91)

We have to run the solid mount on the eBay/ptk kit.