RPrezas

I was wondering who has tried one of these. I saw a 38MM 2 bolt to 44MM Vband adapter, I wanted to know if they make any difference, or if its just a waste since the pipe to the flange is a 38MM. Any input is helpful, thanks

1999Black_Z28

iTrader: (1)

I use one without any issues

edit: shown in this picture

RPrezas

nice, what wastegate are you using and how much boost?

1999Black_Z28

iTrader: (1)

Precision PW46. Currently holding my TC78 at 6psi...haven't tried anything lower

RPrezas

not bad, I have that same kit too so that helps me. thanks!

02LS1ram

iTrader: (17)

Where did you get that flange setup at. I have a completely different looking one from HS

1999Black_Z28

iTrader: (1)

LT1RAY

iTrader: (21)

Jon can also weld a bigger flange onto the hotside. He did it for my RG-45 wastegate!

a-low

iTrader: (26)

I tried using a similar from ebay advertised as 38 to 44 but woulnt fit my tial wg
so just had a flange and support bracket welded on.

V-seriesTech

iTrader: (5)

I have a 38mm 2 bolt to 44mm v band on my setup...haven't had the chance to test if it holds boost or not.

RPrezas

If I knew he did that I would of done that.. dammit! haha

hmm.. so then I should stay away from the Ebay version?

well, it seems like its holding up pretty good with 1999Black_Z28. I will have a very similar setup to his except with an LQ4

a-low

iTrader: (26)

I would stay away fron the ebay one and go with these guys are getting.
Sellers name is wyntonm he did refund me but i was out on shipping both ways