106lsxcamaro

I have a low mounted turbo and just wondering where others may have there oil return fitting on the motor. Should i run a scavenge pump if i ran it to my where my oil level sensor was because mines a blow through carb set up. thanks

Cam72aro

iTrader: (28)

Mine is low mounted. It's even with the balancer. I run a pump to the oil level sensor hole.

106lsxcamaro

if you dont mind me asking what kind of pump are you using and do you know the thread pitch on the level sensor or did you weld a fitting?

Cam72aro

iTrader: (28)

I used the turbowerx base pump. Has performed flawlessly. I has a -12 line in and out of it. Into the pan is a -12 to 3/4". I opened the hole a bit then tapped it with a 3/4" npt tap.

fastsspr

iTrader: (49)

Where you put the drain fitting ?
in the timing cover or oil pan?

samdogmx

iTrader: (14)

I've also had good luck with the turbowerx base pump. I ran a -10an from a small sump I made to the pump & them -10an to the timing cover.

actually mine is for sale since Im changing my setup.

Cam72aro

iTrader: (28)

I return it into the oil level sensor hole in the oil pan.

ACCLR8N

Cam72aro, how many miles do you have on your return pump?

Cam72aro

iTrader: (28)

Its been running for over a year and around 1000 miles on it.