DopeFedZ

iTrader: (34)

I've been gathering parts for sometime and I've finally started working on the car again. Filling up bottles was starting to get old and I want to have the power available at all times. Im still going to keep a small kit on the car for those just in case situations.

Past two days I worked on mounting the new radiator and stock fans. Finished most of that up today and will start working on mounting the intercooler tomorrow.

Bob@BruteSpeed

iTrader: (16)

Nice pic's! What head unit are you going to use? Bob

DopeFedZ

iTrader: (34)

Im running a 408 and f1r.

Bob@BruteSpeed

iTrader: (16)

I'll keep any eye on your build, it's going to make some power. Bob

ramairetransam

iTrader: (18)

running corvette accessories ??

Rise of the Phoenix

iTrader: (27)

I bet you'll be happy. What bracket you going to run?

DopeFedZ

iTrader: (34)

I hope so!
All I run is the waterpump and alternator. I found an aftermarket bracket that will align the fbody alternator to the corvette belt line.
A&A bracket.

98blackbirdta

iTrader: (7)

Told ya it would work

DopeFedZ

iTrader: (34)

Gonna work on installing the edelbrock proflo intake today that way i can see how I need to mount the intercooler. Should have some new pics this afternoon.

conan

iTrader: (5)

Looking like a good start, good luck with the build.

ProChargerTECH

Dig it!

KilerTA

iTrader: (70)

Thats prety cool are you going to be running a 8 rib set up or something else to battle belt slip. I only ask this is i antisipate a issue moving up to a Novi 2200 on my fbody with a corvette A&A bracket with fbody accessorys.

http://i768.photobucket.com/albums/x...psbc82e25e.jpg

http://i768.photobucket.com/albums/x...psa0887f94.jpg

DopeFedZ

iTrader: (34)

Sticking with 8 rib setup for now.
Mocked up the intake today

manfred717

iTrader: (9)

I am keeping an eye out on this build, can't wait to see how it turns out. If you don't mind, could you share what balancer you are using to make this work?

DopeFedZ

iTrader: (34)

I have a Innovations West C5 8 rib balancer I need to install.

DopeFedZ

iTrader: (34)

Worked on mounting the intercooler today. Also started mocking up some of the piping. Gonna need to cut the underside of the hood a decent amount to clear everything but it should be ok.

ramairetransam

iTrader: (18)

nice mounting , i wanted to do that , almost no pipe from the charger to the ic .



hood latch?

DopeFedZ

iTrader: (34)

Hood latch is coming off. Will be running some aerotech latches.

ajrothm

Looking good looking good!

Hey while youre in there.. tack weld the water pump pulley to the shaft. An F1R is a bitch to turn and it WILL walk the pulley off the shaft, then the belts will start shredding on the rear edge of the pulley...

FYI..

DopeFedZ

iTrader: (34)

Thanks for the heads up. I will definitely do that.