what intake manifold should i get with my procharged 408
#1
what intake manifold should i get with my procharged 408
well im been waiting for my clutch for over a month now and im getting bored
i already had my FAST 90/NW setup so thats what im using. and since i havent finished with the dyno im thinking maybe i should change it up now before the tune it done. every talks about loosing low end tq with certain setups. but this in not a daily driver and loosing low end tq for better flow through out the rpms i can take be it i WILL NOT BE ABLE TO PUT ALL the power down to the ground in city streets as it is
thanks steve
just wanted to ***** out some pictures.. like i said bored lol
here it is when car was maybe 2 years old back in 2004
i already had my FAST 90/NW setup so thats what im using. and since i havent finished with the dyno im thinking maybe i should change it up now before the tune it done. every talks about loosing low end tq with certain setups. but this in not a daily driver and loosing low end tq for better flow through out the rpms i can take be it i WILL NOT BE ABLE TO PUT ALL the power down to the ground in city streets as it is
thanks steve
just wanted to ***** out some pictures.. like i said bored lol
here it is when car was maybe 2 years old back in 2004
Last edited by SVC707; 10-23-2006 at 02:32 PM.
#3
i thought about going back to an LS6 that was my factory manifold. i was thinking about going with the GMPP carb intake. since i already have speedince rails i just need the manifold and intake elbow correct? i want everything to look different, as in when the hood opens people will just go DAMN. plus giving more room to grow. i hate my intercooler piping so i will be redoing that too. and also putting a straight standing radiator.
#7
Originally Posted by KHShapiro
check out the link in my sig , go to page 3
i vote Vic Jr.
i vote Vic Jr.
where do i get this manifold from and can i still use the fuel rails i have with new mounts. and i think the best place to get the elbow was intake elbows or something...
Trending Topics
#8
Originally Posted by Frost
If I'm not mistaken the Vjr is slightly taller... the GMPP will likely clear the hood easier.
#16
TECH Fanatic
iTrader: (17)
Originally Posted by 2MUCHBOOST
I would go with the carb intake on the 408. You will have great top end power on it and you have enough cubes to make up for down low
#20
TECH Fanatic
iTrader: (17)
Originally Posted by SVC707
looks like the gmpp has the same mounting for my speedinc rails and will sit lower, but will cost a tad bit more overall after needing drilling for the injectors, and the gmpp needs a different gasket than the oem round gaskets