sweetmongo

Working on installing pacesetter on the driver side and cannot get the steering shaft off. I have both bolts out and it won't budge, I've tried PB and dead blow too. Is this how it is supposed to come out? Is there another way to get the header up there? Can I grind off that tab on the motor?

sscamaroburn02

iTrader: (14)

Is this going on a Camaro?

Infantrymarine

iTrader: (3)

Any luck?

demonspeed

iTrader: (7)

There have been some instances where people have replaced the steering racks with rebuilt LT1 units thanks to unknowing parts countermen. They bolt right in; however, they mess up the alignment of the steering shaft.

idle

iTrader: (5)

Not sure on the shaft but I had to grind down this little square corner off of my block to get my 1 7/8" TSP's to fit; 99 TA.

Unertl42

iTrader: (63)

I ground the tab off of my motor. Just ensure that everything is covered that you don't want aluminum dust to get into.