elite22xl

iTrader: (1)

i ordered my QTP headers and catted y pipe, they are on their way. i was under the car and noticed that i may have a problem with my cutout in the I pipe. how far back does the QTP catted y pipe come and how much of the I pipe do you have to cut off?

LS1LT1

iTrader: (16)

You will have to cut some of the I pipe down a bit but if your cut out is positioned in the typical/proper spot then you should be ok.

Ryan02SS

iTrader: (3)

Yeah about 4-8" need to be cut off the I pipe, can't really remember the exact measurement. This is because of the added length of the Flowmaster Merge Collector.

elite22xl

iTrader: (1)

sounds good, anybody have an exact measurement for the cut? the cutout really cuts it close on 8 inches and if i cant make it im just going to go out and get a pipe, would like to have it in advance before the headers. exact measurement anybody? thanks again guys

elite22xl

iTrader: (1)

just measured, 9 1/2 inches from the front of the pipe to the cutout, do you think i can make it?

f-bodman

I only cut about 7 inches off my gmmg. Good Luck.

elite22xl

iTrader: (1)

wow thats close, anybody else have a measurement?

NviouSS

iTrader: (8)

i fit my qtp ory up and it looks like i'm going to have to cut approx. 4" off for it to work.

elite22xl

iTrader: (1)

ok thanks guys, anybody have to cut over 8 inches?

NviouSS

iTrader: (8)

are you installing them yourself?

elite22xl

iTrader: (1)

yes i am

NviouSS

iTrader: (8)

it takes a while but worth it imo.

elite22xl

iTrader: (1)

yea im in no rush, car is not daily driven, i enjoy taking my time and getting the job done right the first time