98sspullin'em

iTrader: (-1)

i need to know what bolts you used when you put the block on the engine stand?? the one i have, you put the bolts in the back of the stand and screw it into the block?? they only have to be about 3-5 inches long,,, what is the size of them?? and is there any that came off the engine that i can use?? everything is off of it but the cam!! thanks

UGotBeaT

You can use some bell housing bolts but they're not long enough so I just went to autozone and bought 3 that were like an inch longer.

Kens_02SS

iTrader: (11)

Call this guy at Panadigm Engineering ( Charlie) they build engine stands: 661-296-4147

LS1x2

iTrader: (11)

ACE Hardware stores have tons of bolts. I beleive they are M10x1.5. You can measure the length you need.

robertbartsch

...home depo sells bolts too...

Q

iTrader: (18)

yup home depot 10x 1.5 (70mm) on ac delco stand.