need answers
03-08-2010, 10:29 PM
#4
(click the link below)
After i did a search, i realized there was way too much info for you to read just to answer your question... I do recommend you search the forums anyways, just to learn and familiarize yourself with everything, especially the stickys.
I will however redirect you ls1 how to, because there is a great write up on doing a cam install without removing lifters. Is it recommended? Most would say no, depending on the cam grind. But it's up to you to decide. I hope no one opposes to me posting this link.
http://www.ls1howto.com/index.php?article=23
After i did a search, i realized there was way too much info for you to read just to answer your question... I do recommend you search the forums anyways, just to learn and familiarize yourself with everything, especially the stickys.
I will however redirect you ls1 how to, because there is a great write up on doing a cam install without removing lifters. Is it recommended? Most would say no, depending on the cam grind. But it's up to you to decide. I hope no one opposes to me posting this link.
http://www.ls1howto.com/index.php?article=23
03-08-2010, 10:34 PM
#5
Teching In
Join Date: Feb 2010
Location: Goochland VA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
when i did mine i just spun the cam a couple times and pulled it out. the lifters have a little "pocket" the get stuck in. from cam going out to new cam in was probably less than 5 minutes. if a lifter falls however...