Would this pose an issue to grind down?
#1
Launching!
Thread Starter
iTrader: (19)
Join Date: May 2008
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Would this pose an issue to grind down?
If I grind down the the little ridge on my new 243s on the valve cover bolt holes?
see this link for the pictures and reference as to what I am talking about.
https://ls1tech.com/forums/generatio...-than-ls6.html
The spring compressor tool i am currently using is owning my hands, and is taking entirely too long. I had borrowed the Crane spring tool from a friend, but because of that ridge on the bolt holes, it won't sit right. I am just talking about grinding down enough so the tool sits flush again.
see this link for the pictures and reference as to what I am talking about.
https://ls1tech.com/forums/generatio...-than-ls6.html
The spring compressor tool i am currently using is owning my hands, and is taking entirely too long. I had borrowed the Crane spring tool from a friend, but because of that ridge on the bolt holes, it won't sit right. I am just talking about grinding down enough so the tool sits flush again.