LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

PTV question

Thread Tools
 
Search this Thread
 
Old 04-05-2008, 07:25 AM
  #1  
Teching In
Thread Starter
iTrader: (2)
 
dennyd's Avatar
 
Join Date: Jun 2006
Location: Virgina beach va
Posts: 24
Likes: 0
Received 0 Likes on 0 Posts
Default PTV question
Ok I have a 230/236 .612/.607 111LSA+1 XFI/XFI lobes with 7.425 push rods stage 1 PRC cnc ls6 heads #799 cometic .040 gaskets stock bottom end with k-tech rod bolts. Will I have any piston to valve problems or will it be ok?
dennyd is offline  
Reply Like
Old 04-05-2008, 09:05 AM
  #2  
TECH Senior Member
iTrader: (23)
 
brad8266's Avatar
 
Join Date: Aug 2005
Location: Watertown, NY
Posts: 8,797
Likes: 0
Received 0 Likes on 0 Posts
Default
You might be kinda close, measure to be sure.
brad8266 is offline  
Reply Like
Old 04-05-2008, 09:10 AM
  #3  
TECH Senior Member
iTrader: (8)
 
SOMbitch's Avatar
 
Join Date: Sep 2007
Posts: 6,881
Likes: 0
Received 3 Likes on 3 Posts
Default
I am pretty sure you are OK on PTV but you knew the answer before you posted. When in doubt....... MEASURE!!! If you need pointers search it on here. Claying doesn't take much time and it's cheap.
SOMbitch is offline  
Reply Like
Back to Subforum
Generation III Internal Engine
View Next Unread
new motor, spun bearing




Advanced Search

All times are GMT -5. The time now is 10:21 PM.