Braciole

iTrader: (6)

I am working on my 60ft with my LS2 Vette Ive been LOW 1.7s
What is the best 60ft you got with (IRS) on a bolt on Vette with MANUAL trans???? Im on my third rear I dont want there to be a 4th.
I had some issues with wheel hop that are now resolved, but could come back if conditions change. I leave around 2500 and try to slip the race clutch,
(race clutches dont slip) I will be try a higher RPM on Wed at a track rental.
Ill post back.
Thanks for all responses
Mike

Danny

iTrader: (16)

What tires are you using.

I remember out of the few times I've been to the track lately i've only got one 1.860ft time and consistent 1.9s. That's with INVOs.

Braciole

iTrader: (6)

Ive been 1.71 with bfgs. now i using MT DRs. Id likr to get into the 1.6s
Anyone else??
Thanks for any replies

Danny

iTrader: (16)

What BFGs did you use?

Max@Cartek

I've gone mid 1.6's.

Danny

iTrader: (16)

Was that on street tires or DRs???

Max@Cartek

Drag Radials

Danny

iTrader: (16)

Oh ok.

Phil99vette

iTrader: (11)

I've been 1.39, consistent 1.41-1.45 on ET Streets.

JUNK

I get 1.39-1.42s all day long if the track prep is good. I have been doing this w/ a stock c-5 3:42 diff using only the dte shafts and it holds up to the automatic. A 6 speed w/ a metallic clutch and/or wheel-hop will kill an otherwise fine set-up.

JoeyGC5

iTrader: (24)

Phil's the man with the low 60' 6 speed runs. On M/T ET Streets i've been consistent 1.57-1.62 60's with a 5k clutch slip of the Textrallia single and a few different motors.

Braciole

iTrader: (6)

I ve have seen you in action!

Braciole

iTrader: (6)

Hey Phil What car are you running the 1.4s in?

Braciole

iTrader: (6)

So Far the Best time with a LS2 Bolton Manual is 1.6s???
Thats the class Im running, Im trying to figure out where I should be.
Thanks for all the replies!

JoeyGC5

iTrader: (24)

If you can get consistent/low 1.6's then I'd say your doing well. Only more practice and aggressive launch will really help out. IMO

Ryne @ CMS

iTrader: (10)

back in 05 i was cutting low 1.5's/high 1.4's in my 04 z06 with a et street bias plys.

i recently cut a 1.57 in my 08 z06 on a 315-30-18 et street radial

WKMCD

iTrader: (2)

That was Phil's 346 M6 C5. His current project is MUCH faster...

Braciole

iTrader: (6)

Thanks for all the replies!!!