98Camarod

iTrader: (43)

My gauge pillar is 2 1/16" and the eboost2 is 2 5/8". So where is everyone putting there eboost2?

98Camarod

iTrader: (43)

I know I'm not the only one that has wondered this.

98Camarod

iTrader: (43)

Found a thread, apparently the 2 5/8" will be ending up in the ac vent unless someone else has another idea, preferably with some pics

sujomatt

iTrader: (7)

buy a gauge cup in that size. then just mount it in the corner by the apillar - should work

98Camarod

iTrader: (43)

I have a fuel pressure gauge, wideband and a boost gauge already on a pillar. I was going to remove the boost gauge thats in the pod and put the eboost there, but its too large

sujomatt

iTrader: (7)

ah so u want to keep it in the apillar if possible

98Camarod

iTrader: (43)

I'd like to, but I don't think thats an option with the larger gauge.

73 nova guy

iTrader: (8)

well in the vent it will be nice and cool!

SSilverSSurfer

iTrader: (8)

i made the eboost 2 fit in my pillar, i dont know what size the gauge openings are but i had to open the hole a little more to get the eboost to fit

98Camarod

iTrader: (43)

They have two sizes, I've got the larger one coming. I've seen that you can get the smaller of the two into the pillar, but not the larger gauge.

98Camarod

iTrader: (43)

Does anyone know where to get the plate for the vent to mount the eboost2?

Brent@LPE

Here is a pic of a Plate we made for the larger EB2 sorry its not so good of a shot put you get the Idea.

Brent

SpraydZ

iTrader: (2)

Nice setup.. Clean and simple just how I like it..

tahoeryan

iTrader: (2)

Here's a better picture.

98Camarod

iTrader: (43)

^^That would be nice to do.

z28adiction

iTrader: (1)

i really like how you mounted yours. anyone have anyother pics of theres? especially in camaros.

98Camarod

iTrader: (43)

I made a plate to cover the hole on each side of the eboost2. It was to big to do it like I wanted so the plate overlaps but it looks better than not having anything. This is pretty much the only place this big bitch can fit. Now I just have to figure out how to use the damn thing. It has set points and boost setpoints and all kinds of other shiza I've got no clue

Brent@LPE

^^^^ We pretty much did the same thig on TahoeRyan's car only put the aluminum behind the plastic.


Brent

98Camarod

iTrader: (43)

I was going to do that too, but this is the bigger gauge. This one takes up the entire vent. I had one cut out for the way you have it, and tried it and it was a no go.

Sluggish

iTrader: (10)