wheelies247

Im in the middle of builing a motor trans comb and wanted to know if there is anyone out there that has done this swap

and what parts will i need ????

Thanks

thesource

iTrader: (60)

What are you installing it in?

wheelies247

I plan on putting it in a mustang

my plan now is to finish up my motor trans and rear then look for a roller

thesource

iTrader: (60)

Are you planning on using a Mustang T5 behind the LS2?

wheelies247

thats the plan??

thesource

iTrader: (60)

Unless its a built Z spec or better T5, I would not suggest going with one personally. With that said, the Quicktime RM-6037 should work for you.

wheelies247

How much does the bell housing go for ball park??

And that will work for my set up


cause the way im looking at this is if i get a built t56 and clutch and flywheel thats all going to cost me around $2300 dollar ??? Give or take

cost of the bell housing and a built t5 with clutch and fly wheel would be about half the price ??? Right ???

thesource

iTrader: (60)

To buy a bellhousing and build a T5 that will live behind the power you intend on making, its going to be close to what a T56 will run. I cannot discuss pricing since I am not a sponsor on here.

wheelies247

Coool thanks

which one is the over all better street/strip trans that will take the abuse and cheap to rebuild

wheelies247

Thesource

is there anything else that i would need that you know of