Dart 205's on a 408?
#1
12 Second Club
Thread Starter
iTrader: (17)
Join Date: Dec 2004
Location: Cooper City, FL
Posts: 1,449
Likes: 0
Received 0 Likes
on
0 Posts
Dart 205's on a 408?
are these to small? I have them already, if money was no object I'd spring for some TFS 235's and mill them down to 64cc.
these are BONE STOCK darts, I would of course have them cleaned up a bit, which I have heard makes a drastic difference with these heads.
rest of the setup
SCR 12:1
DCR 8.55:1
iron block
4.030 diamond 6cc dish
callies compstar rods
callies compstar crank
248/252 .625/.625 112 +2
HS rockers
morel lifters
fast 90/90
42lb inj.
Meizere EWP
TSP 1 7/8" headers
TSP true duals w/ bullets
what kind of power could I expect to make with these heads? or will it just choke the motor ?
I also plan on a healthy shot of spray on top...2 stages.
Chad
these are BONE STOCK darts, I would of course have them cleaned up a bit, which I have heard makes a drastic difference with these heads.
rest of the setup
SCR 12:1
DCR 8.55:1
iron block
4.030 diamond 6cc dish
callies compstar rods
callies compstar crank
248/252 .625/.625 112 +2
HS rockers
morel lifters
fast 90/90
42lb inj.
Meizere EWP
TSP 1 7/8" headers
TSP true duals w/ bullets
what kind of power could I expect to make with these heads? or will it just choke the motor ?
I also plan on a healthy shot of spray on top...2 stages.
Chad
Trending Topics
#8
TECH Senior Member
iTrader: (8)
Tough spot. If the rest of your setup didn't look so nice I would say get a VJ and run them......Damn.....Maybe see if you can get a deal on some used AFR 225's and sell the Darts......Or a new set of Dart 225's are reasonable but sometimes they need a lot of VJ work as is so.....I dunno.....
#9
12 Second Club
Thread Starter
iTrader: (17)
Join Date: Dec 2004
Location: Cooper City, FL
Posts: 1,449
Likes: 0
Received 0 Likes
on
0 Posts
Tough spot. If the rest of your setup didn't look so nice I would say get a VJ and run them......Damn.....Maybe see if you can get a deal on some used AFR 225's and sell the Darts......Or a new set of Dart 225's are reasonable but sometimes they need a lot of VJ work as is so.....I dunno.....
but then that brings up another question...I know alot of guys mill these heads down and don't suffer any loss of flow, but how low is "to low" ?
Chad
#10
TECH Senior Member
iTrader: (8)
I'm really thinking about just biting the bullet, saving up some more dough and getting the right heads...TFS 235's milled
but then that brings up another question...I know alot of guys mill these heads down and don't suffer any loss of flow, but how low is "to low" ?
Chad
but then that brings up another question...I know alot of guys mill these heads down and don't suffer any loss of flow, but how low is "to low" ?
Chad