Magnamouth Anyone?
#1
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: P-Town, IN
Posts: 1,358
Likes: 0
Received 0 Likes
on
0 Posts
Magnamouth Anyone?
Any of you LT1 guys running magnamouth on your cars? I would love some clips if you have them. I have a friend that has a '94 Z28 and is thinking of going this route, but isn't quite sure yet and wants to hear some clips if you could.
It's much appreciated guys
It's much appreciated guys
#4
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: P-Town, IN
Posts: 1,358
Likes: 0
Received 0 Likes
on
0 Posts
Actually it's a loudmouth system with a magnaflow bullet muffler in place of the loudmouth resonator...
I have borlamouth which is a borla xr1 muffler in place of the loudmouth resonator.
I have borlamouth which is a borla xr1 muffler in place of the loudmouth resonator.
#6
TECH Fanatic
iTrader: (26)
Join Date: Mar 2010
Location: Milledgeville, GA
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
I just removed a loudmouth because it was too loud for local law enforcement. When I had it off I made a quick run with an open intermediate pipe and it sounded about the same as the full loudmouth. lol Is there a brand bullet that I could put in it's place that would be a good bit quieter, but not kill the flow?? I'm not looking for stock or near stock decibel levels......just not looking for a ticket.
#7
TECH Resident
iTrader: (21)
Join Date: Aug 2006
Location: Wichita KS
Posts: 947
Likes: 0
Received 0 Likes
on
0 Posts
I just removed a loudmouth because it was too loud for local law enforcement. When I had it off I made a quick run with an open intermediate pipe and it sounded about the same as the full loudmouth. lol Is there a brand bullet that I could put in it's place that would be a good bit quieter, but not kill the flow?? I'm not looking for stock or near stock decibel levels......just not looking for a ticket.
I too would like to hear a magnamouth setup as im tossing around the same idea.
Trending Topics
#9
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: P-Town, IN
Posts: 1,358
Likes: 0
Received 0 Likes
on
0 Posts
****Note, it is not a direct bolt in replacement. You will have to cut down some of the I-pipe and have the XR1 muffler welded in place. It's a tight fit and close to the drive-shaft and hangs pretty low, but it is doable**** (I'm lowered w/ Stranos and I've only scraped twice)
Anyone have magnamouth...I know there has to be a few...????