Anybody interested in sound clips from...
#7
TECH Addict
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Posts: 2,350
Likes: 0
Received 0 Likes
on
0 Posts
I don't have them on, I'll get what you want when I do though. I hate how there's no info out there on them. I got them on sale and figure if i don't like them after install SOMEBODY out there will buy them. Even if I lose too much money at least I gave cheap stainless true duals a shot.
Trending Topics
#13
TECH Addict
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Posts: 2,350
Likes: 0
Received 0 Likes
on
0 Posts
Received the duals today. I'll be installing them tonight. May be able to get some quick idle, or simple driving vids, but nothing substantial until later maybe early next week.
Last edited by LSWHO; 01-12-2011 at 02:58 PM.
#15
TECH Addict
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Posts: 2,350
Likes: 0
Received 0 Likes
on
0 Posts
Got the exhaust bolted up last night. Took forever with those brand new clamps to get them to stretch and actually seal. Exhaust hangers are being welded on tonight so hopefully I'll have something for you soon.
So far the sound is very clean and I'm very satisfied. It's quiet at idle but very deep. Sounds awesome with throttle. Didn't go crazy because a freakin' coat hanger was holding my exhaust up... which broke on the very short neighborhood drive.
So far the sound is very clean and I'm very satisfied. It's quiet at idle but very deep. Sounds awesome with throttle. Didn't go crazy because a freakin' coat hanger was holding my exhaust up... which broke on the very short neighborhood drive.
#17
TECH Addict
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Posts: 2,350
Likes: 0
Received 0 Likes
on
0 Posts
Looks just like this, and there's sound clips too I think. It's an LS1 so remember it'll sound better with a cammed LT1 haha.
http://www.fastlsx.com/forums/showth...p?t=1342190958
http://www.fastlsx.com/forums/showth...p?t=1342190958
#19
TECH Addict
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Posts: 2,350
Likes: 0
Received 0 Likes
on
0 Posts
Damn! I meant to. It's easy to figure out though. On the passenger side the pipe leading to the X is on piece. Where it connects to the X needs to be cut down. I cut off about 1.5" and it straightened it out. Without that cut the exhaust aims toward the drivers rear corner.