electric cutouts in here
#1
TECH Resident
Thread Starter
iTrader: (31)
Join Date: Jun 2009
Posts: 950
Likes: 0
Received 0 Likes
on
0 Posts
electric cutouts in here
Im installing a dmh electric cutout, already have the qtp cutout welded on my intermediate pipe just before it goes over the axle, and trying to add the dmh motor. It seems like the end of the electronic motor would hang a little low so I was wondering if you guys could post pics of yours so I have a good reference. And how/where you hooked them up up to and including the switch. Thanks.
#7
TECH Apprentice
iTrader: (10)
Join Date: Feb 2005
Location: Kernersville, NC
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
It's actually a raceland cutout and the motor is built onto the ypipe. I cut it at the merge, cut a hole in my hooker catback i-pipe, and welded it up. The wires are ran up through the drain plug under the passenger seat. The raceland cutout has a keyfob and a wireless module that I've got mounted under my console. I'm not sure about reliability, but it's definitely cool to be outside the car and hit the wireless switch.
Trending Topics
#11
Teching In
Join Date: Nov 2010
Location: Bethlehem, PA
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
This past summer I ran one of these, until the damn thing burned out on me. Even though it burned out it was still one of the most fun mods I've done to my car. Being able to go from the sound of open headers to stock exhaust tone within 3seconds was awesome . I had mine mounted off of the I pipe. I had it tucked up by the rear passenger seat. There's sort of a hump that it should tuck into. Best spot I could find for clearance. The switched was mounted in my ashtray since I don't smoke and also concealed it from nosey mechanics. Sorry I have no pictures; I had a ton of them, but my pc fried and I lost them all.