HSW switch panel wiring?
10-16-2011, 09:50 AM
#1
9 Second Club
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: WV
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
HSW switch panel wiring? this thing: http://www.harrisspeedworks.com/prod...4&cat=0&page=1
I've got one but a bit unclear on a few things...
Does the plate need to be glued in to keep it from rattling around? I'm thinking so.
Wiring for the LED. Instructions say pin 2 to ACC. WTF does that mean? Easy way to wire it to get the lights to work?
The electrical connectors seem a bit small for 1/4" QD connectors but are too big for .187. Crimp on the .25 with needle nose?
I've got one but a bit unclear on a few things...
Does the plate need to be glued in to keep it from rattling around? I'm thinking so.
Wiring for the LED. Instructions say pin 2 to ACC. WTF does that mean? Easy way to wire it to get the lights to work?
The electrical connectors seem a bit small for 1/4" QD connectors but are too big for .187. Crimp on the .25 with needle nose?
10-16-2011, 06:43 PM
#2
9 Second Club
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: WV
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
well I figured out that the ACC pin is supposed to go to the device being switched. still a bit concerned about the loose fit of the QD connectors on the pins.
