todds69

iTrader: (2)

Just put the tsp tsunami cam in my car. It has 7.400 length hardened pushrods in it now and I'm getting 1 3/4 turns on the exhaust rocker bolt and 1- 1 1/8 turns on the intake rocker bolt before it bottoms out. I'm doing the eoic method and starting to count the turns at zero lash. So the question is........ Should I put a longer pushrod on the intake valves or run it the way it is?

KCS

iTrader: (20)

I used two different lengths for my build. I think it's about .040" per full turn, so a .025" longer pushrod should take up the 5/8" turn difference.

Gray86hatch

iTrader: (83)

Mine are diff length

Tim

todds69

iTrader: (2)

well i put it together anyways just to see... crunk it up and its got some pretty loud lifter noise so i guess i'll order some pushrods. too bad i cant just order 8 lol

bww3588

iTrader: (49)

I'm sure you can. My buddy dropped one on the ground during install and to be safe, ordered a new one from comp.

DONAIMIAN

iTrader: (18)

Sure you can. Call up Trend or Manton, those are the two major pushrod makers.

Gray86hatch

iTrader: (83)

Manton and smith brothers stuff is nicer than trend. Manton has built and shipped mine same day on two orders.
Tim

DONAIMIAN

iTrader: (18)

Smith brothers skipped my mind. Also really nice stuff. I'll agree with you on the Manton stuff. Ordered on Monday, had it by Thursday. Really good considering it was custom.