alternator pulley - 4 groove
#1
Staging Lane
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
alternator pulley - 4 groove
I am making a bracket to install a cs130 alternator low on the passenger side of a 5.3 and run it off the 4 groove side of the balancer. I need the 4 groove pulley for my alternator and can not find any info on what years and vehicles used them.
I seen info on this earlier today while I was at work but can not remember what it was under.They were using a alt out of a van I believe. I've searched and searched.
I seen info on this earlier today while I was at work but can not remember what it was under.They were using a alt out of a van I believe. I've searched and searched.
#6
TECH Resident
iTrader: (4)
Join Date: Feb 2009
Location: Ohio
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
A Nissan Z31 alternator pulley should be 4 groove (87-89). I was going to use one to run my Nissan power steering pump from the AC section of my LS balancer before deciding on manual steering. Making it fit your alternator may be an issue though.