Accufab, 102mm TB, EFI Intakes, timing controller, Window switch, 2 speed glide...
#1
TECH Apprentice
Thread Starter
iTrader: (94)
Join Date: Oct 2005
Location: Huffman, Texas
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Accufab, 102mm TB, EFI Intakes, timing controller, Window switch, 2 speed glide...
Category: Engine - Intake/Fuel
Price: $100
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): TX
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
$1,100.00 Sold
Victor JR EFI for LS1 power coated Black with Aeromotive fuel rails, 46 pound EV1 Injectors, Aarons Intake Elbow, PTM 102mm Throttle body
$1,100.00 Sold
PSI Conversion Wiring Harness for a 6 speed (Glide, 350, 400) Swap. The injector plugs are for truck injectors, I have a new set of EV6 plugs to get with this. Brand new never installed with Computer
$450.00 Sold
I will Seperate:
LS3/L96 Intake with Rails $450.00
Victor Jr Intake with Rails $600.00
102mm TB with Sensors $400.00Sold
Accufab TB with TPS $400.00Sold
LS3 42 Pound injectors $150.00 (I also have extensions) Sold
EV1 46 Pound Injectors $200.00Sold
Aarons Intake Elbow $150.00
Built for 1k hp Powerglide with Trans Brake, built in electric Shifter, turbo Input Shaft, Locar dip stick tube. $1,200.00obo Sold
3500-3700 Turbo spline Stall $400.00 Sold
Brand new Revmax 6000 Stall for turbo spline, Was built for a 632BBC $450.00
LINGENFELTER LNC 2000 timing controller/ 2-step. Used to pull timing with nitrous is armed $225.00obo Sold
NOS window Switch 2-stage $125.00
I'm going Carb so that I do not have to deal with tuning and I can spray the **** out of it...
281-701-1909
Last edited by Bad Chad; 06-03-2013 at 01:07 AM.
Trending Topics
#8
Still have the PSI Harness and PCM? Shoot me some <at>gmail<dot>com
I assume this is for a cable throttle body and is for an LS1? Anything done to the PCM?
Thanks bud,
Dave
I assume this is for a cable throttle body and is for an LS1? Anything done to the PCM?
Thanks bud,
Dave