TRANSAMWS6-98

iTrader: (1)

Is it bad if i was to spray with low compression heads , a turbo cam, and a vortec supercharger with an after cooler, plus all bolt ons?

kp

iTrader: (34)

If its done right the only thing you will hurt is your cheeks from the smile it will put on your face. Just a 50 shot will work wonders, it dropped 1/2 a second on my old ATI car and a 15lb bottle lasted forever. I would mainly use it when it was hot out to keep the car running in the 10s on a 90 degree day. Here is a vid of it with a 50 shot on the blower on a 85 degree 90% humidity evening - it works




Click here to see Video

99Z51R

iTrader: (18)

Not at all, but as suggested stay with a small shot, unless your forged. I ran a 50 on top of my mag before going forged. I just installed a second stage on top of the 100 shot I now have on my forged bottom. Can't wait to get it dyno'd with this set up I'll launch with the first stage around 50 then come on with the second stage of 100-150

black_z

iTrader: (4)

Been to CF lately? I remember watching your car break right out of the hole last year, did it end up being the clutch?

99Z51R

iTrader: (18)

Nope, it was the output shaft. Snapped clean as a whistle. Now have hardened shafts and a strut brace on the tranny. Only went once this year, made first pass on the new motor and then it was suggested that I get a roll bar Looking at putting a wolfe in soon, I wanna see what this new set-up will do.

Eric