heads for a 346-348
11-14-2005, 01:10 PM
#1
7 Second Club
Thread Starter
iTrader: (42)
Join Date: Jun 2004
Location: paducah, ky
Posts: 4,558
Likes: 0
Received 0 Likes
on
0 Posts
heads for a 346-348 I'm looking at some of the heads people are delivering for a small bore motor...
and it seems the TEA 5.3 stage 3 are the best heads avialable for $2,000
has anyone else found any different?
and it seems the TEA 5.3 stage 3 are the best heads avialable for $2,000
has anyone else found any different?
11-14-2005, 10:29 PM
#3
7 Second Club
Thread Starter
iTrader: (42)
Join Date: Jun 2004
Location: paducah, ky
Posts: 4,558
Likes: 0
Received 0 Likes
on
0 Posts
question about the 5.3 and the afr 205
without milling the 5.3 aproximately what CR would i be at? I'd like to see about 11.25:1
would milling the 205 to get the 11.25 hurt the flow numbers enough to make them flow less than the TEA 1.5 stage 3?
without milling the 5.3 aproximately what CR would i be at? I'd like to see about 11.25:1
would milling the 205 to get the 11.25 hurt the flow numbers enough to make them flow less than the TEA 1.5 stage 3?
