TXCAMSS

iTrader: (60)

I installed the "Save Yo Azz" bars today. Maybe a little late, but before I did major damage If I would have ordered them earlier, I wouldn't have flattened my Drivers side header as you can see in the pic. That's a hard lesson learned. IMHO, It's a great investment. I hope to be testing them soon!

Thanks Mad Man!!!!

11SECSS

iTrader: (199)

I hope your not just holding them with the clamp....lol

TXCAMSS

iTrader: (60)

They are held by the clamp in the front and the rear is secured with a large K-member bolt. The pressure will be on the down stroke of the landing so it souldn't have any force pulling down on them. They sure feel solid.

ls1408cp

iTrader: (37)

the clamp is fine and they are an important item.

MADMAN

iTrader: (4)

They look like these fit a little better for your ride height. Go try them out and let me know!!

ATVracr

iTrader: (5)

They have saved my *** already once.

Broke one of the clamps off and got some good sized dents in mine

They work!


Wheelie bars are gay

Doofy

iTrader: (21)

I got mine on last week. Too bad the motor is toast now. Oh well, they will get used with the new motor.

JRracing

iTrader: (35)

Those are cool as hell. I'm wondering if I'm going to need some. I'm very worried about banging my new QTP's all up.

Madman, how much for a set???
Also, I seen those cleco's that you were telling me about at the good guys car show today. I should have bought a set. But did'nt want to carry them around all day.

ty_ty13

iTrader: (42)

www.thunderracing.com

TXCAMSS

iTrader: (60)

Yeah these look like they are perfect. I hope to test them sometime this weekend.

They cost a lot less than a new oil pan and a set of headers. Ask me how I know and check out the drivers header in one of those pics. That was before the SYA bars and when I was only making 459 rwhp

It's cheap insurance IMO.

JL ws-6

iTrader: (50)

Looks like you could have used them a little earlier judging by your headers


They look good though, they are a definate purchase I will make once I put a k member on my car.

02SOMWS6

iTrader: (6)

i just installed mine. very easy to install

TS6

iTrader: (41)

Can a set be made for stock K member cars?

ls1408cp

iTrader: (37)

the stock kmember hangs lower so they are not needed
here are mine

Coach 02 A3 Z/28

iTrader: (10)

They look nice James. Now get to the track already.

Coach

ApacheDrill

iTrader: (21)

Do they need to be clamped or can you weld them..

JRracing

iTrader: (35)

So if I have a stock K member then they are not needed?

MADMAN

iTrader: (4)

Do not weld them they are a consumable part. They are made to be destroyed.

ApacheDrill

iTrader: (21)

Word.. that sounds evil