Crane Rocker Backed Itself Off
#1
TECH Veteran
Thread Starter
iTrader: (12)
Join Date: Dec 2004
Location: Rockville, MD
Posts: 4,354
Likes: 0
Received 0 Likes
on
0 Posts
Crane Rocker Backed Itself Off
im not blaming anybody but me for this one, although i tightened the jamnut as much as i could and somehow it still backed off. the rocker is in relatively good shape, the retainer/valve tip/locks are not hurt. a new rocker will be ordered and a 4.5mm allen SOCKET will be use to torque down the jam nuts too ...20? ft/lbs. when i heard it clunk i felt like this
#3
TECH Veteran
Thread Starter
iTrader: (12)
Join Date: Dec 2004
Location: Rockville, MD
Posts: 4,354
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by orangeapeel
I hate tq'ing down rockers....I have mushroomed so many sockets. I knew that thing was tight though.
#5
TECH Veteran
Thread Starter
iTrader: (12)
Join Date: Dec 2004
Location: Rockville, MD
Posts: 4,354
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by orangeapeel
Craftsman baby! Sears was about pissed off when I came in with 4 10mm's that were all split. HAHA.
Trending Topics
#9
TECH Veteran
Thread Starter
iTrader: (12)
Join Date: Dec 2004
Location: Rockville, MD
Posts: 4,354
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by vettenuts
Did you do the final step in the Vinci instructions? I tightened my jam nut to 12 lb-ft and then tighten the jam nut and hex nut together 1/8 turn. My problem has always been getting them off again.