SELLSZ06

iTrader: (12)

Iam putting on the carb style intake with a elbow and I dont know how to hook it up with the brake booster. On the back of my factory ls6 intake where it receives the hose from the brakebooster there is a sensor there that hooks up to one of the wires that run on the back of the engine. How are you guys adapting that sensor onto the Edelbrock's threaded 3/4" bung from the brake booster?

ls1408cp

iTrader: (37)

I think its a 3/8s fitting 90degree for a 1/2inch hose I bought it from summit I think

SELLSZ06

iTrader: (12)

what about the factory sensor that was connected to the manifold end of the hose?

ls1408cp

iTrader: (37)

I dont know what you are talking about

SELLSZ06

iTrader: (12)

Ill get a pic, if you have a ls6 intake run your hand to the back of it and you will see it

ls1408cp

iTrader: (37)

map sensor

SELLSZ06

iTrader: (12)

408ls1cp
this is what Iam talking about.
http://s96.photobucket.com/albums/l1...urrent=ls6.jpg

ls1408cp

iTrader: (37)

it is the map sensor. The vaccum line on the right side of my pic is attached to it.