Complete Interior Transformation
#1
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: May 2007
Location: Tyler, Tx
Posts: 1,377
Likes: 0
Received 0 Likes
on
0 Posts
Complete Interior Transformation
I've finally finished my Leather seat conversion and they look good and very expensive. They went from brown/tan cloth to Complete Black Leather which I hand made myself. Now the rest of the panels in the car are tan and I want to switch them all to black with a few exceptions...
The carpet and headliner are staying tan, making some black leather visors next and covering the door panels in black leather and bottom part with some nice black carpeting.
All the plastic panels are my question...
Should I paint the plastic panels or wrap them in vinyl or leather??? And have you seen any panels that were wrapped?? I'm scared I won't be able to make the vinyl stick properly and it'll peel up soon.
The carpet and headliner are staying tan, making some black leather visors next and covering the door panels in black leather and bottom part with some nice black carpeting.
All the plastic panels are my question...
Should I paint the plastic panels or wrap them in vinyl or leather??? And have you seen any panels that were wrapped?? I'm scared I won't be able to make the vinyl stick properly and it'll peel up soon.
#6
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: May 2007
Location: Tyler, Tx
Posts: 1,377
Likes: 0
Received 0 Likes
on
0 Posts
I've yet to find a camaro around here with ebony interior, I've found one camaro period and it's purple with purple painted interior and a smashed hood... all the parts I need are ruined...
Trending Topics
#9
TECH Fanatic
I'm doing this right now. I only Use 3M glue for this, Fastbond 30 & Spray 74. I hate the gray plastic feeling of my interior. Check out the result.
Last edited by vikingramair; 06-17-2007 at 02:00 AM.
#10
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: May 2007
Location: Tyler, Tx
Posts: 1,377
Likes: 0
Received 0 Likes
on
0 Posts
Did you use leather or vinyl? And how did you prep the surface? You use any heat for shaping? Give up some details, I'd like to know what to expect when I begin this...