MadMike 97 Z28

iTrader: (3)

anyone have any ideas on how to get this damn thing out? its the pilot bearing that comes with spec 2 clutch. a pilot bearing romoval tool isnt even working you slide hammer the hell out of this thing and it still wont move even cut up the bearing trying to make it weaker and the thing still wont budge!!!

Gary Z

Liquid Wrench - let it soak overnight.

MadMike 97 Z28

iTrader: (3)

ok ill try that thanks.

anyone else have any other ideas.

Ferocity02

iTrader: (60)

It nothing works you may have to chisel it out with a hammer and flat head screwdriver, but be careful.

mrhzk35404

iTrader: (7)

Try to jam the slide hammer in on an angle. I had one hell of a time getting mine out.

LSXNV

iTrader: (1)

don't know about the bearing, but i used grease and a peice of round stock that matched the opening on my bushing. if that doesn't work, put a little heat around the bearing and a little dry ice inside the bearing.

taws6m6

iTrader: (37)

We welded the damn removal tool to the thing when we did my spec. Slide hammer the hell out of it, it came out after a few pulls. I had the exact same problem

MadMike 97 Z28

iTrader: (3)

YES SHES OUT!!!!! took some liquid wrench and a little bit of drilling up the bearing then she popped out with a few blows of the slide hammer.

thanks fellas.

DarknessLS1

dremel