chevrolet02z28

Ok so after having my jet hot headers n yh sitting around for liek almost a year i talked to the guy whos installing them and he wants instructions to make sure theres no hastle bs custopmizing **** to make them fit? does any one have instructions for these damn things i dont seem to have em... if not has ne one had a problem customizing **** on em...? remember this is the jet hot LTS and there y-pipe... got it from lmperformance.....

SOMbitch

iTrader: (8)

Get somebody else to install them. Anybody who can do this doesn't need directions. It's so straight forward. Might have to disconnect steering shaft depending on header. Take some time off and do it yourself maybe then you'll know it's done right'

quikz

iTrader: (7)

Disconnect spark plug wires

Remove manifolds and stock y pipe

Install headers from underneath vehicle

Passenger side slides in easily

Driver side had to remove the little oil cover above the oil filter to get it in

Install y-pipe

They went in easily for me.

Wingman WS6

iTrader: (3)

Passenger side is a breeze!
Drivers side I've heard of people grinding off part of something to make it fit.
I just got a jack under the tyranny closer to the engine and pulled the motor mount off and jacked the engine up a but. Slid in pretty ez after that.

BlackBADaSS02

iTrader: (17)

When I installed my Jet Hots, I had to cut off a casting tab off the block to get the drivers side to slide in.