View Poll Results: How much did it cost you for TD's?
$200-$300
6
20.00%
$300-$400
6
20.00%
$400-$500
7
23.33%
$500-$700
3
10.00%
$700 and Up...
8
26.67%
Voters: 30. You may not vote on this poll
How much did it cost you for TD's?
06-08-2008, 12:54 AM
#1
TECH Resident
Thread Starter
iTrader: (17)
Join Date: Sep 2006
Location: AZ
Posts: 838
Likes: 0
Received 0 Likes
on
0 Posts
How much did it cost you for TD's? Hey guys, just curious how much it cost you to get your TD setup. Please specify if you had it custom or if you put it on yourself. Thanks.
06-08-2008, 05:04 PM
#5
TECH Enthusiast
iTrader: (1)
Join Date: Jul 2006
Location: JAX, FL
Posts: 600
Likes: 0
Received 0 Likes
on
0 Posts
1:54 am to 2:30 pm doesn't equal 30 minutes......To the OP, I am looking into having an over-the-axle H-pipe setup made and it seems like it will be around $500.
This thread has turned into a math extravaganza.... Trending Topics
06-08-2008, 08:49 PM
#12
TECH Resident
iTrader: (7)
Join Date: Apr 2007
Location: STL, Mo
Posts: 954
Likes: 0
Received 0 Likes
on
0 Posts
No I do not. The reason it cost that much is because the shop told me I would get tremendous hp gains if they stuck some of those turbonator things in there. So I bought about 50 of those things and put them end to end from the X back. I also went stainless the whole way with mand. bends. I also did custom loops on both sides of the axle. They said that that would give me a gain to if i went under and then up over the axle and under again. It sounds pretty wicked!
06-08-2008, 10:11 PM
#16
11 Second Club
iTrader: (8)
Join Date: May 2007
Location: Memfrica, TN
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
I built my own $80 for 2 1 chamber "flowmonsters" $60 for a box of 2 1/2" manderal bends and $40 for pipe and hangers plus some solid mig wire a little gas and about 12 hours of time. but ive got a H pipe and its over the axle
06-08-2008, 10:31 PM
#17
TECH Fanatic
iTrader: (21)
Join Date: Oct 2006
Location: Everywhere
Posts: 1,105
Likes: 0
Received 0 Likes
on
0 Posts
No I do not. The reason it cost that much is because the shop told me I would get tremendous hp gains if they stuck some of those turbonator things in there. So I bought about 50 of those things and put them end to end from the X back. I also went stainless the whole way with mand. bends. I also did custom loops on both sides of the axle. They said that that would give me a gain to if i went under and then up over the axle and under again. It sounds pretty wicked!
