main and rods bearings
#1
TECH Fanatic
Thread Starter
iTrader: (3)
Join Date: Mar 2007
Location: Middle east , Kuwait
Posts: 1,591
Likes: 0
Received 0 Likes
on
0 Posts
main and rods bearings
hey , i bought a used crank but it's honed +10 now i want to buy main and rods bearings what size can i buy STD or .... ? thanks and please explane to me.
#2
give me a call i have the bearings in stock and can ship them out to you today
ADMIN: NON SPONSOR - CONTACT INFO REMOVED
ADMIN: NON SPONSOR - CONTACT INFO REMOVED
Last edited by Brains; 06-20-2008 at 05:13 PM. Reason: Non sponsor - contact info removed
#4
TECH Fanatic
iTrader: (12)
Join Date: Oct 2004
Location: Republic of Tx
Posts: 1,129
Likes: 0
Received 0 Likes
on
0 Posts
They are Clevite race bearings. You can not just slap bearings in an LS1. Or any engine for that matter. You have to measure, measure, and re-measure. I have the bearings in stock ready to ship.
Trending Topics
#8
If the crank has been ground -.01 then you need the bearings listed for that size. They will be .01 smaller than the STD ones. If you use STD on a ground crank then it is way too loose.