lt1 Cranks
#1
Staging Lane
Thread Starter
Join Date: Dec 2011
Location: Santa Ana,California
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
lt1 Cranks
HI there i recently spun my bearings and the crank got damaged bad I decided to just buy one thats .10 .10 Well my question is that if all lt1 cranks interchange my motor is a 93 lt1. which crank do i need a 1 rear main seal or 2 rear main seal i.d like to know because i want to buy the right part.
#3
Launching!
iTrader: (1)
Join Date: Aug 2002
Location: Tulsa, OK
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
I would get the block checked.
If it's a main bearing which I assume that you spun the mains might have to get looked at and see if it's ok.
I spun a main bearing (cracked crank) and it trashed the block beyond repair.
If it's a main bearing which I assume that you spun the mains might have to get looked at and see if it's ok.
I spun a main bearing (cracked crank) and it trashed the block beyond repair.
#7
Staging Lane
Thread Starter
Join Date: Dec 2011
Location: Santa Ana,California
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
it was a rod bearing that got spun .. the reason i.m getting a 10/10 is because i cant afford a new one and beacause i getting the crank thats 10/10 with matching bearing for 150 ... so i,m still confused do they interchange or not??
Trending Topics
#10
9 Second Club
iTrader: (7)
OP, the parts themselves, blocks, cranks, main caps from all lt motors interchange.....obv 2-bolt and 4-bolt respectivly......however all will require machining usually due to tolerances, wear, and prior modifications.......main bearing clearance, rod bearing clearance and main cap housing bore diameters should all be checked durring assembly as with any engine....but the cranks do interchange..........any 1 piece GM GEN I or GEN II (LT) crank will go in your motor......as with rods they are the same......and acutally rod bearings interchange with all GM engines from SBC to LT to LS1....they all run the GM 2.100 rod journal size.......
for example i run a Callies 2-Piece main SBC crank in my car but i just bought an adapter to go from 2 piece crank to a 1 piece block.......my rods are olivers for a sbc and as are my pistons......it all interchanges........